User's Manual Part 1

Mounting the 2.4GZ OpenWay Remote Mount Gas Module
TDC-0838-001 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount 13
Proprietary and Confidential
To mount the 2.4GZ OpenWay remote mount gas module on the adapter plate
1. Take the 2.4GZ OpenWay remote mount gas module and the two 1-inch mounting screws from the
Remote Mount Installation kit. Place the back of the remote endpoint against the face of the adapter plate.
The adapter plate mounting lug (1) must be positioned just above the endpoint mounting lug recess (2).
2. Push up on the 2.4GZ OpenWay remote mount gas module until the adapter plate mounting lug (1) is as
far as possible inside the endpoint mounting lug recess (2).
3. Install the two 1" endpoint-mounting screws from the installation kit.
4. Tighten the endpoint mounting screws evenly in an alternating fashion. Itron recommends 9 to 12 inch-
pounds torque.
Adapter Plate Mounting Positions
The following pictures show adapter plates mounted on horizontal or 45-degree angle pipes.
Caution Regardless of the pipe's direction, the adapter plate mounting lug must always be at the top or
bottom. (Bottom lug installation for inverted curb meter module mounting).