User's Manual Part 1

2.4GZ OpenWay Remote Mount Gas Module Installation
TDC-0838-001 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount 7
Proprietary and Confidential
Installation Prerequisites
The following tools are required to install, program, and check the 2.4GZ OpenWay remote mount gas
module. Some specific tools may be required dependent on meter or instrument type.
Medium flat-blade screwdriver
Small flat-blade screwdriver
Medium Phillips-drive screwdriver
Hand pliers
Side-cutting pliers
1/4-inch nut driver or similar blunt tool
One-inch width putty knife
Adjustable wrench
3M crimping tool: E-9R, E-9BM, E-9C/CW, E-9E, or E-9Y. Itron recommends the E-9R tool.
All-weather electrical tape
Size T-10 Torx screwdriver
Itron programming device to program and check 2.4GZ OpenWay remote mount gas module installation
and operation:
FC300 with SRead with Endpoint-Link or Endpoint Link Pro version 5.5 or higher or
FC200 (with Bluetooth-enabled) handheld computer loaded with Endpoint-Link or Endpoint-Link Pro
software to program and check endpoint.
ZigBee Belt-clip Radio with Endpoint-Link or EndPoint-Link Pro software - to program and check
2.4GZ OpenWay remote mount gas module installation and operation.
Caution You must program the 2.4GZ OpenWay remote mount gas module with a Bluetooth-
enabled FC200 or FC300 with SRead handheld computer and ZigBee Belt Clip Radio loaded
with EndPoint-Link Pro software version 5.3.1.26 or version 5.5 for Itron Private Profile (IPP)
gas modules (OWG-5001-XXX).
Endpoint-Link Pro software version 5.5 must be used for Smart Energy Profile (SEP) gas
modules (OWG-5002-XXX).