User's Manual

Optional Direct Connect Remote Antenna Installation
TDC
-0909-006 100W/100W+ and 100WP/100WP+ Datalogging Water ERT Module Installation Guide 35
Proprietary and Confidential
Industry Canada Conformity
The radio transmitter (IC:864D-100WC, IC:864D-100WD) has been
approved by Industry Canada to operate with the antenna types listed
below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device.
Le présent émetteur radio (IC: 864D-100WC, IC:864D-10
0WD)
a été a
pprouvé par Industrie Canada pour fonctionner avec les
types d'antenne énumérés ci-dessous et ayant un gain admissible
maximal et l'impédance requise pour chaque type d'antenne. Les
types d'antenne non inclus dans cette liste, ou dont le gain est
supérieur au gain maximal indiqué, sont strictement interdits
pour l'exploitation de l'émetteur.
Specification
Part number CFG-0900-003
Gain 2 dBi
Horizontal beamwidth Omni-directional
Impedance 50 ohms
Termination Proprietary
Installing the Remote Antenna
Metal lids on water pit boxes require a through-lid solution for optimal ERT module radio performance. The
remote antenna is designed to fit in a pit lid hole with a diameter of 3/4-inch and lid thicknesses from 1/4-inch
to 1-3/4-inch.
Caution Remove cable or twist ties from the antenna cable to prevent damage to the ERT module
or antenna.