User's Manual

Using the Itron Cable Armor
TDC
-0909-006 100W/100W+ and 100WP/100WP+ Datalogging Water ERT Module Installation Guide 45
Proprietary and Confidential
3. Wrap the entire piece of electrical tape around the ERT module cable near the inline connector.
4. Beginning over the installed electrical tape, twist the Itron cable armor onto the ERT module cable using a
right-handed twist.
Important You must twist—not wrap—the cable armor onto the ERT module cable. Wrapping the cable
armor can cause the stainless steel jacket to warp.
Warning You must begin wrapping the cable armor over portion of the cable protected by the electrical
tape. If you do not begin to wrap the cable armor over the protected portion of the ERT module cable, a
cut cable could cause an ERT module/register communication failure.
5. Continue to twist the cable armor onto the ERT module cable until the cable armor covers the entire cable.
Warning You must continue to wrap the cable armor onto the cable protected by the electrical tape. If
you do not twist the cable armor over the protected portion of the cable, you cut initiate a cut cable and
cause and ERT module/register communication failure.
6. Remove any leftover materials from the customer premises. Discard or recycle leftover materials.