User's Manual

Using the Itron Splice Kit
TDC
-0909-006 100W/100W+ and 100WP/100WP+ Datalogging Water ERT Module Installation Guide 42
Proprietary and Confidential
2. Carefully place the connector and wires into the jaws of the crimping tool. Make sure the wires remain
fully inserted in the gel-cap connector.
3. Crimp the connector by squeezing the handles until the connector cap is fully seated. Continue to apply
pressure for three seconds.
4. A connector is crimped properly when the top of the movable yellow center (1) is flush with the top of the
connector body (2).
Warning Crimping the connector forces some sealant out of connector. The sealant protects the inside of
the connector against insects, moisture, and other contaminants. The sealant may cause minor eye and
skin irritation. Avoid eye contact. Avoid prolonged or repeated skin contact. Contact Itron Support for
Material Safety Data Sheets (MSDS).