User's Manual

Using an Inline Connector
TDC-0909-004 100W and 100WP Datalogging ERT Module Installation Guide 40
Proprietary and Confidential
3. Install the security seal as shown. Push it until it snaps into place.
Note For future meter or ERT module servicing, break the security seal by pulling the seal apart. The
original protective connector covers can be reused if kept clean and dry. Install a new security seal after
servicing either device. To order replacement security seals, see the Water ERT Module Ordering Guide
(PUB-0063-001).
Caution Shield connectors with protective environmental covers (see 100W and 100WP ERT Module
Mounting Accessories). Do not leave an exposed connector in the field.
Environmental caps employ multiple seals to increase cap life. Environmental cap design allows utilities
to install the ERT module and install a Leak Sensor or optional remote antenna at a future date.