User's Manual

Optional Direct Connect Remote Antenna Installation
TDC-0909-004 100W and 100WP Datalogging ERT Module Installation Guide 35
Proprietary and Confidential
Industry Canada Conformity
This radio transmitter (IC:864D-100WC) has been approved by
Industry Canada to operate with the antenna types listed below
with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this
device.
Le présent émetteur radio (IC: 864D-100WC) a été approuvé par
Industrie Canada pour fonctionner avec les types d'antenne
énumérés ci-dessous et ayant un gain admissible maximal et
l'impédance requise pour chaque type d'antenne. Les types
d'antenne non inclus dans cette liste, ou dont le gain est supérieur
au gain maximal indiqué, sont strictement interdits pour
l'exploitation de l'émetteur.
Specification
Part number
CFG-0900-003
Gain
2 dBi
Horizontal beamwidth
Omni-directional
Impedance
50 ohms
Termination
Proprietary
Installing the Remote Antenna
Metal lids on water pit boxes require a through-lid solution for optimal ERT module radio performance. The
remote antenna is designed to fit in a pit lid hole with a diameter of 3/4-inch and lid thicknesses from 1/4-inch
to 1-3/4-inch.
Caution Remove cable or twist ties from the antenna cable to prevent damage to the ERT
module or antenna.