User's Manual

Installing the 100W and 100WP ERT Module
TDC-0909-004 100W and 100WP Datalogging ERT Module Installation Guide 20
Proprietary and Confidential
5. Position the ERT module and insert a #10 pan head screw in the base mounting tab. Carefully tighten the
mounting screw until the ERT module is secure.
Caution Do not over-tighten the mounting screws. Over-tightening the mounting screws may break the
ERT module mounting tabs.
Shelf Mount Installation
This section describes 100W and 100WP ERT module installation using a shelf mount adapter to mount the
ERT module in a pit lid slot.
Caution Observe the following guidelines for mounting the ERT module using the shelf mount
procedure:
 ERT module positioning other than upright could negatively affect radio performance
and battery life.
 Use only Itron-approved splice kits or inline connectors.
The pit lid and slot must have the correct dimensions for the ERT module assembly to fit properly.