User's Manual

Installing the 100W and 100WP ERT Module
TDC-0909-004 100W and 100WP Datalogging ERT Module Installation Guide 19
Proprietary and Confidential
8. Screw the bottom screw into the pilot hole until snug. Do not over-tighten the mounting screw.
Base Mount Installation
The ERT module may be mounted to a flat surface using the base tab.
Caution Observe the following guidelines for mounting the ERT module using the wall mount
procedure:
 ERT module positioning other than upright could negatively affect radio performance
and battery life.
 Use only Itron-approved splice kits or inline connectors.
Required Mounting Tools and Hardware
 Drill and drill bits appropriate for mounting location material.
 Common hand tools for the selected fastening method.
 Mounting screws: #10 size pan head screws appropriate for the wall or pit box material.
To install the 100W and 100WP ERT module using the base mount procedure
1. Select a flat surface.
2. Position the ERT module vertically.
3. Mark the mounting-hole location.
4. Drill a pilot hole in the mounting location material. Follow the screw manufacturer's recommendation for
the pilot hole size.