User's Guide
Table Of Contents
- Contents
- Before You Begin
- About the 100W and 100WP Datalogging ERT Module
- Connecting, Initializing, and Programming the ERT Module
- Installing the 100W and 100WP ERT Module
- Remote Antenna Installation
- Using an Inline Connector
- Using Gel Cap Connectors and the Itron Splice Kit
- Troubleshooting
- Index
Using Gel Cap Connectors and the Itron Splice Kit
TDC-0909-003 100W and 100WP Datalogging ERT Module Installation Guide 41
Proprietary and Confidential
3. Crimp the connector by squeezing the handles until the connector cap is fully seated. Continue to apply
pressure for three seconds.
4. A connector is crimped properly when the top of the movable yellow center (1) is flush with the top of the
connector body (2).
Warning Crimping the connector forces some sealant out of connector. The sealant protects the inside of
the connector against insects, moisture, and other contaminants.
The sealant may cause minor eye and skin irritation. Avoid eye contact. Avoid prolonged or repeated skin
contact. Contact Itron Support for Material Safety Data Sheets (MSDS).