User's Guide
Table Of Contents
- Contents
- Before You Begin
- About the 100W and 100WP Datalogging ERT Module
- Connecting, Initializing, and Programming the ERT Module
- Installing the 100W and 100WP ERT Module
- Remote Antenna Installation
- Using an Inline Connector
- Using Gel Cap Connectors and the Itron Splice Kit
- Troubleshooting
- Index
TDC-0909-003 100W and 100WP Datalogging ERT Module Installation Guide 40
Proprietary and Confidential
This section describes connecting the 100W and 100WP ERT module to the water meter register using gel cap
connectors.
Required Materials
• E-9R 3M® gel cap crimping tool
• Itron Splice Kit (OEM-0034-002)
1. Push two wires as far as possible into the connector.
Caution Do not strip insulation from the ends of the wires before inserting them into the connector.
2. Carefully place the connector and wires into the jaws of the crimping tool. Make sure the wires remain
fully inserted in the gel-cap connector.
A
PPENDIX
B
Using Gel Cap Connectors and the Itron Splice Kit