User's Guide
Table Of Contents
- Contents
- Before You Begin
- About the 100W and 100WP Datalogging ERT Module
- Connecting, Initializing, and Programming the ERT Module
- Installing the 100W and 100WP ERT Module
- Remote Antenna Installation
- Using an Inline Connector
- Using Gel Cap Connectors and the Itron Splice Kit
- Troubleshooting
- Index
Installing the 100W and 100WP ERT Module
TDC-0909-003 100W and 100WP Datalogging ERT Module Installation Guide 31
Proprietary and Confidential
4. Insert the mounting plate over the U-bolt's threaded screw ends. Attach the two wing nuts over the clamp
screw ends and tighten the wing nuts until snug (to a minimum of 5-inch pounds) to prevent device
rotation on the pipe. After you tighten the second wing nut, check the Leak Sensor to verify the device is
snug. If the sensor moves, tighten the wing nuts until there is no movement.
Caution Do not tighten the Leak Sensor to more than 20 inch-pounds. Over-tightening could damage the
Leak Sensor housing and/or the pipe.
Note Leak Sensor mounting orientation is not critical. Orient the sensor to best accommodate your
installation. The most important installation practice is to mount the sensor securely to the pipe.