User's Guide
Table Of Contents
- Contents
- Before You Begin
- About the 100W and 100WP Datalogging ERT Module
- Connecting, Initializing, and Programming the ERT Module
- Installing the 100W and 100WP ERT Module
- Remote Antenna Installation
- Using an Inline Connector
- Using Gel Cap Connectors and the Itron Splice Kit
- Troubleshooting
- Index
Installing the 100W and 100WP ERT Module
TDC-0909-003 100W and 100WP Datalogging ERT Module Installation Guide 23
Proprietary and Confidential
To install in lids with holes using the Pit Lid Mounting Kit (CFG-0771-011)
This section provides the instructions to install the 100W and 100WP ERT module in a pit lid with a hole
using the Pit Lid Mounting Kit (CFG-1300-004).
1. Verify you have the following items to complete the installation.
A Retainer clip
B Pit lid with a pre-drilled hole
(simulated pit lid material shown)
C Retainer clip collar
D 100W and 100WP ERT module