User's Guide
Table Of Contents
- Contents
- Before You Begin
- About the 100W and 100WP Datalogging ERT Module
- Connecting, Initializing, and Programming the ERT Module
- Installing the 100W and 100WP ERT Module
- Remote Antenna Installation
- Using an Inline Connector
- Using Gel Cap Connectors and the Itron Splice Kit
- Troubleshooting
- Index
Installing the 100W and 100WP ERT Module
TDC-0909-003 100W and 100WP Datalogging ERT Module Installation Guide 21
Proprietary and Confidential
To install using the shelf mount adapter
1. With the foam spacers facing up, insert the shelf mount adapter into the opening in the disk.
2. Push the adapter into the opening gently until the adapter snaps into place. Insert the shelf mount adapter
into the ERT module antenna slot pushing firmly with your thumb until the adapter tab locks into place in
the ERT module antenna slot opening.
3. Slide the adapter assembly into the pit lid with the foam spacers positioned on each side of the pit lid slot.