User's Manual

About the 100W-R and 100WP-R Endpoints
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 6
Proprietary and Confidential
3. Quiet Mode
OEMs can configure the endpoint for quiet mode after programming and direct mounting the 100WP-R in
a factory.
An endpoint is awakened from quiet mode and enters Run Mode in one of two ways:
Counting two pulses. The pulses are counted internal to the 100WP-R while it is in quiet mode.
Receiving a two-way command, such as a Read ERT using FDM.
If an endpoint installed in quiet mode is not bubbling up SCM or NIM messages, it may be due to zero
consumption on the endpoint, such as a vacant or vacation home. Initiate a two-way command (for
example, perform a Read ERT with FDM) before removing the unit.