User's Manual

TDC-0909-002 100W and 100WP Pit Datalogging Water Endpoint Installation Guide 1
Proprietary and Confidential
Document Conventions
Convention
Example
Itron product part numbers are noted in
parentheses.
To install the endpoint (ERW-1300-XXX), do the
following steps.
Hypertext links are in blue.
See the Copyright Page for identification information.
Note A Note indicates neutral or positive information that stresses or
supplements important points of the main text. A note supplies information that
may apply only in special cases.
Caution A Caution advises users that failure to take or avoid a specified action
could result in a loss of data.
Warning A Warning advises users that failure to take or avoid a specified
action could result in physical harm to the user or the hardware.
Document Purpose
This document provides the installation instructions for the 100W and 100WP. Mounting options for the
100W endpoint include rod mount, wall mount, through-lid (remote antenna), and shelf-mount installation.
The 100W is available with the following configurations:
Integral connector
5-foot open-end cable
20-inch open-end cable
An optional Itron Leak Sensor is available for all three configurations to provide leak monitoring capability.
100W endpoint configurations provide an easy interface to several register types. The 20-inch cable variant
allows meter manufacturers to mount the endpoint directly to their respective meter registers before delivery
to the installer.
Caution Installing an integrated 100W endpoint and meter register in a water pit box reduces the endpoint's
RF signal distance significantly. If read reliability is a problem, install a remote antenna or select a new
installation method.
C H A P T E R 1
Before You Begin