User's Manual

Installing the 100W Endpoint
TDC-0909-002 100W and 100WP Pit Datalogging Water Endpoint Installation Guide 15
Proprietary and Confidential
Wall Mount Installation
Select a flat vertical mounting surface. Install the endpoint in an upright position. Locate the endpoint as high
as possible. To mount the endpoint to the wall in a water pit box, select a mounting location on the inside of
the pit box and try to maintain a distance of one to two inches from the bottom of the pit box lid.
Caution Observe the following guidelines for mounting the 100W using the wall mount procedure:
Endpoint positioning other than upright could negatively affect radio performance
and battery life.
Use only Itron-approved splice kits or inline connectors.
The 100W is suitable for use with up to 300 feet of Itron approved cable.
Required Tools and Hardware
Itron 100W Shelf Mount Kit
To install the 100W endpoint using the wall mount procedure
1. Select a vertical surface in the pit box or on a wall (for example, an endpoint mounted in a basement).
2. Position the endpoint vertically so the top of the endpoint is between 1 and 2-inches below the bottom of
the lid.
3. Mark the location of the top mounting hole.
4. Drill a pilot hole in the pit box wall. Follow the screw manufacturer's recommendation for the pilot hole
size.