User's Manual

Index
TDC-0951-001 100W-R and 100WP-R Datalogging Water Endpoint Installation Guide 36
Proprietary and Confidential
Symbols & Numbers
100WP-R Operating Modes, 5
100W-R and 100WP-R endpoints Accessories, 10,
14
100W-R and 100WP-R Models, 3, 19
100W-R and 100WP-R Transmission Modes, 4
100W-R Operating Modes, 4
A
About the 100W-R and 100WP-R, 3
Attaching the Backplate, 10
B
Battery Life, 4
Before You Begin, 1
C
Connecting the 100WP-R to a Remote Meter
Register, 8, 27, 32
Connecting the 100W-R to a Remote Meter
Register, 7, 27
Connecting the Leak Sensor to the 100W-R and
100WP-R endpoints, 19
D
Direct-Mounting to the Meter Register, 10, 25
H
How This Document is Organized, 2
I
Initializing the 100W-R, 7
Installing the 100W-R and 100WP-R Endpoints,
10
O
Optional Leak Sensor Installation, 19
P
Pipe Mount Installation, 10, 14
Pipe Preparation, 20
Programming, 9
Programming and Connecting the 100W-R and
100WP-R, 3, 7, 23
R
Related Documents, 2, 9
Remote Mount Installation, 10, 23
Required Equipment, 20
Required Tools and Hardware, 24
T
To attach an encoder/pulser and leak sensor
backplate, 12
To attach an encoder/pulser only backplate, 11
To install on a flat surface, 24
To install tamper seals and cable ties, 17
To install the 100W-R and 100WP-R endpoints to
a Badger Direct-Mount register, 26
To install the Elster/AMCO (ABB) Scancoder,
InVISION, or Digital Direct-Mount, 30
To install the Leak Sensor on a pipe (up to 2 1/2-
inch OD), 22
To install the Leak Sensor on a pipe or meter
insetter, 20
To mount the 100W-R and 100WP-R endpoints on
the adapter plate, 17
To mount the adapter plate in other positions, 15
To mount the adapter plate on a vertical pipe, 14
Troubleshooting, 35
U
Using an Extension Cable, 8
Using Gel-cap Connectors, 8, 19, 27, 33
V
Verifying 100W-R and 100WP-R Endpoints
Operation, 9
Index