User's Manual

Installing the 100W Endpoint
TDC-0909-002 100W and 100WP Pit Datalogging Water Endpoint Installation Guide 25
Proprietary and Confidential
To connect the Leak Sensor to the 100W endpoint
Caution Verify you have the correct 100W or 100WP endpoint. Leak Sensors must mount to Port B (top
port) of the endpoint. Connecting the LS to Port A (bottom port) will cause electrical damage to the LS
and 100W endpoint.
1. Remove the environmental cap from the 100W endpoint blue connector (B).
B. 100W blue connector: Leak Sensor connection
A. 100W black connector: Register connection
2. Remove the environmental cap from the Leak Sensor connector. Verify the connectors (100W LS
connector and the Leak Sensor connector) are clean and dry.
3. Align the Leak Sensor connector with the endpoint's blue connector and insert.