User's Manual

Installing the 100W Endpoint

TDC-0909-002 100W and 100WP Pit Datalogging Water Endpoint Installation Guide 24

Proprietary and Confidential

Optional Leak Sensor Installation

Leak Sensors (LS) analyze water flow sound patterns to detect new, evolving, and pre-existing leaks. LS

analysis data is uploaded to mlogonline™ Network Leak Monitoring for data analysis and accessed through a

secure Internet portal unique to your utility. This section describes installation of the Leak Sensor (LS) in a

100W system.

The 100W endpoint stores 20 days of Leak Sensor data. On the 21st day, the 100W begins to write over stored

data in a first in, first out manner.

The 100W automatically detects the presence of connected Leak Sensors. The 100W will automatically detect

the Leak Sensor within 22.5 minutes and begin reading Leak Sensor data. To immediately detect the Leak

Sensor and begin reading data, perform a Check ERT with a handheld computer running FDM software.

The LS is used in conjunction with both indoor (basement) and outdoor (mounting on the exterior of the

house) 100W endpoint installations. LS devices are mounted on a water service pipe or meter insetter (meter

horn) and connect to the appropriate endpoint wires as described in To connect the Leak Sensor to the 100W

endpoint on page 25. The mounting bracket shipped with the Leak Sensor accommodates an (up to) 1-1/2-

inch OD pipe. An optional mounting bracket is available for pipe sizes (up to 2 1/2-inch OD).

Required Equipment

Equipment

Itron Part Number

Description

Leak Detection Sensor

LDS-0001-002

LDS with inline connector, environmental connector cap; 5-foot

cable, and mounting bolt (fits up to 1 1/2-inch OD pipe).

Optional mounting bracket

CFG-0349-002

Mounting bolt fits up to 2 1/2-inch OD pipe.

100W endpoint

ERW-1300-002

Dual port 100W for LS and environmental connector caps.

25-foot extension cable

CFG-0349-101

25-foot cable with coordinating connectors (LS blue connector,

100W LS environmental replacement

cap

MSC-0019-005

Protects Leak Sensor connector when the Leak Sensor is not

connected to the 100W endpoint.

Warning When the 100W or 100WP is installed but the Leak Sensor is not attached, you

must protect the blue Leak Sensor port with the environmental cap (MSC-0019-005). If you

remove the Leak Sensor from the 100W, the environmental cap must be replaced to protect

the connector.