User's Manual

Installing the 100W Endpoint

TDC-0909-002 100W and 100WP Pit Datalogging Water Endpoint Installation Guide 21

Proprietary and Confidential

Required Tools and Hardware

This mounting method requires the Pit Lid Mounting Kit. Refer to the 100W Installation Methods Overview

(PUB-1300-004) for guidance on which kit to install for different pit lid material and traffic conditions.

Pit Lid Mounting Kit (CFG-1300-004)

Note The Pit Lid Mounting Kit is not intended for applications involving vehicular traffic.

Use the Remote Antenna Kit in incidental traffic areas (such as residential environments).

To install in lids with holes using the Pit Lid Mounting Kit (CFG-0771-011)

This section provides the instructions to install the 100W endpoint in a pit lid with a hole using the Pit Lid

Mounting Kit (CFG-1300-004).

1. Verify you have the following items to complete the installation.

Retainer clip

Pit lid with a pre-drilled hole

(simulated pit lid material shown)

Retainer clip collar

100W endpoint