User's Manual

TDC-0909-002 100W and 100WP Pit Datalogging Water Endpoint Installation Guide 37
Proprietary and Confidential
This section describes connecting the 100W endpoint to the water meter register using gel cap connectors.
Required Materials
E-9R 3M® gel cap crimping tool
Itron Splice Kit (OEM-0034-002)
1. Push two wires as far as possible into the connector.
Caution Do not strip insulation from the ends of the wires before inserting them into the connector.
2. Carefully place the connector and wires into the jaws of the crimping tool. Make sure the wires remain
fully inserted in the gel-cap connector.
A P P E N D I X B
Using Gel-cap Connectors