User's Manual
Table Of Contents
- Before You Begin
- About the 100W Datalogging Endpoint
- Initializing and Connecting the 100W Datalogging Endpoint
- Installing the 100W Datalogging Endpoint
- Optional Remote Antenna Installation
- Using an Inline Connector
- Index
Appendix A Using an Inline Connector
34 TDC-0909-000 100W Datalogging Endpoint Installation Guide
Proprietary and Confidential
3. Twist the register cable's black coupling nut to align the two tabs.
4. Install the security seal as shown. Push it until it snaps into place.
Note For future meter or endpoint servicing, break the security seal by pulling apart.
The original protective connector covers can be reused if kept clean and dry. Install a
new security seal after servicing either device. To order more parts, see the Water
Endpoint Ordering Guide (PUB-0063-001).
Caution Shield connectors with protective environmental covers. Do not leave an
exposed connector in the field.
Leak Sensor connector environmental cover: MSC-0019-005
Register connector environmental cover: MSC-0019-001, 1-year life.
The Leak Sensor environmental Cap employs multiple seals to increase cap life. The
Leak Sensor's cap design allows utilities to install the endpoint and install the Leak
Sensor at a later date.