User's Manual
Table Of Contents
- Before You Begin
- About the 100W Datalogging Endpoint
- Initializing and Connecting the 100W Datalogging Endpoint
- Installing the 100W Datalogging Endpoint
- Optional Remote Antenna Installation
- Using an Inline Connector
- Index
Shelf Mount Installation
TDC-0909-000 100W Datalogging Endpoint Installation Guide 19
Proprietary and Confidential
3. Slide the adapter assembly into the pit lid with the foam spacers positioned on each
side of the pit lid slot.
Correct position for foam spacers
Caution Do not install the adapter assembly in a manner that provides little or
no support under disk's edge.
Incorrect mounting position for foam spacers.
4. The installed position of the endpoint should be vertical and upright when the lid is
replaced on the pit.
Caution When placing the pit lid on to the pit box after shelf mount adapter
installation, use care to avoid pinching or damaging the 100W meter cable. Any
endpoint position other than upright may negatively affect radio performance and
battery life.