User's Manual

Wall Mount Installation
TDC-0909-000 100W Datalogging Endpoint Installation Guide 15
Proprietary and Confidential
5. For concrete-type pit boxes, it may be necessary to use a screw anchor. Choose an
anchor appropriate for a #10 pan head screw.
Caution Do not over-tighten the mounting screws. Over-tightening the mounting
screws may break the endpoint mounting tabs.
6. Start a screw into the pilot hole. Using the top hole of the endpoint, set the endpoint
over the screw head and slide it down so the screw is now at the top of the notch (as
shown). Carefully tighten the screw until snug. Over-tightening the mounting screw
could crack the endpoint housing.
Note If mounting requires a screw anchor, mark the location of the bottom anchor and
remove the endpoint. Drill the required mounting hole, insert the anchor, and re-attach
the endpoint.
7. Holding the 100W in the upright position, drill the second pilot hole. Use the bottom
mounting hole as a template.
Caution Any endpoint position other than upright may negatively affect radio
performance and battery life.
8. Screw the bottom screw into the pilot hole until snug. Do not over-tighten the
mounting screw.