User's Manual
Table Of Contents
- Before You Begin
- About the 100W Datalogging Endpoint
- Initializing and Connecting the 100W Datalogging Endpoint
- Installing the 100W Datalogging Endpoint
- Optional Remote Antenna Installation
- Using an Inline Connector
- Index
Verifying Operation of the 100W Datalogging Endpoint
TDC-0909-000 100W Datalogging Endpoint Installation Guide 7
Proprietary and Confidential
Verifying Operation of the 100W Datalogging Endpoint
Use one of the following handheld computers to verify consumption:
FC200SR handheld computer (Itron part number FC2-0005-004 or FC2-0006-004)
FC300 with SRead
NOTES
Each handheld radio requires special setup and configuration parameters to
successfully read and program 100W products. Refer to the respective
meter reading application for specific instructions.
When comparing the actual register value to that reported by the 100W ,
please keep in mind the endpoint's consumption value is updated once an
hour when it is in a Run Mode.
Caution Do not use ReadOne Pro, FS2PN, FS3PN, or FC200 readers to read
the 100W endpoint. These readers do not keep their receivers on long enough
or at the right frequency to reliably capture a 100W transmission.