User's Manual

Programming the 100T-HON Telemetry Module
TDC
-1346-000 100T-HON Honeywell Telemetry Module Installation Guide 27
Proprietary and Confidential
Program the 100T-HON telemetry modules using:
• An FC200SR handheld computer with Field Deployment Manager (FDM) software version 3.2 or higher
or
• An FC300 with SRead handheld computer with Field Deployment Manager (FDM) software version 3.2
or higher
or
• A 900MHz Belt Clip Radio and your laptop with Field Deployment Manager (FDM) software version 3.2
or higher. The Belt Clip Radio connects to the user-supplied laptop using a USB cable or Bluetooth.
See the Field Deployment Manager Endpoint Tools Mobile Application Guide (TDC-0934) for more complete
programming information.
FC200SR FC300 with SRead 900MHz Belt Clip Radio
To program the 100T-HON telemetry module
1. Program the meter drive rate into the 100T-HON telemetry module using a handheld computer or Belt
Clip Radio and laptop computer. For all programming and Check Endpoint operations using a handheld
computer, hold the handheld as close to vertical as possible. For best success, keep the handheld within six
feet of the target endpoint. Verify you have the correct programming mode (Fixed Network Mode, or
Mobile/Handheld Mode) for your application. Programming parameters are based on the configuration file
loaded into the programming device.
2. To verify 100T-HON telemetry module installation and configuration, FDM supports the ability to read
electronic corrected volume (for Honeywell EVC devices only), read channel 2 if available (electronic
uncorrected or mechanical uncorrected volume—for Honeywell EVC devices only), get tampers, perform
check ERT functions, and perform network coverage tool (NCT) operation.