User's Manual
Table Of Contents
- Contents
- Before You Begin
- About the 100T-HON Honeywell Telemetry Module
- Mounting the 100T-HON Telemetry Module
- Connecting and Configuring the Module and Instrument
- Installation Overview
- Programming the Mercury Instrument Parameters
- Honeywell Instrument Call-In Configuration
- Connecting the 100T-HON Telemetry Module to the Instrument
- Programming the 100T-HON Telemetry Module
Mounting the 100T-HON Telemetry Module
TDC
-1346-000 100T-HON Honeywell Telemetry Module Installation Guide 11
Proprietary and Confidential
1. Place the adapter plate on the pipe bracket with the mounting lug at the top or bottom. The adapter plate
screw bosses fit into the pipe bracket recess.
2. Ensure the adapter plate is positioned as shown below with the mounting lug (1) at the top or bottom. To
install the adapter plate on a vertical pipe, use the two shortest (1/2-inch) adapter plate mounting screws
from the installation kit. Place the mounting screws (2) in the holes shown below.
3. Tighten both screws securely in an alternating pattern. Tighten to 9 - 12 inch-pounds torque.
To mount the 100T-HON telemetry module on the adapter plate
1. Place the back of the module against the face of the adapter plate. The adapter plate mounting lug (1) must
be positioned just above the module mounting lug recess (2).