User's Manual

About the 100T-HON Honeywell Telemetry Module
TDC
-1346-000 100T-HON Honeywell Telemetry Module Installation Guide 6
Proprietary and Confidential
Related Documents
Document Title
Document Part Number
100 Series and CENTRON Tamper Reference Guide
TDC-1028-XXX
Gas and Telemetry Module Ordering Guide PUB-0117-001
100T-HON Honeywell Telemetry Module Specification Sheet Publication 100
Field Deployment Manager Endpoint Tools Mobile Application Guide TDC-0934-XXX
Field Deployment Manager Field Representative's Guide TDC-0936-XXX
Note The last three digits of the user and installation guides represent the document's revision level. The
revision level is subject to change without notice.
Installation Prerequisites
The following tools are required to install, program, and check the 100T-HON telemetry module. Some
specific tools may be required dependent on instrument type.
• Medium flat-blade screwdriver
• Small flat-blade screwdriver
• Medium Phillips screwdriver
• Hand pliers
• Side-cutting pliers
• 1/4-inch nut driver or similar blunt tool
• Adjustable wrench
• 3M Scotchlock E-9Y crimping tool, 3M Scotchlock E-9C cartridge tool, or similar crimping tool
• All-weather electrical tape
• Size T-10 Torx screwdriver
• Itron programming device to program and check 100T-HON telemetry module installation and operation:
• FC300 with SRead loaded with Field Deployment Manager (FDM) software version 1.1 or higher
or
• 900 MHz Belt Clip Radio and a customer-supplied laptop loaded with Field Deployment Manager
(FDM) software version 1.1 or higher
Note Reference the appropriate programming guide or specification sheet for the correct software version
(see Related Documents on page 6).