User's Manual
Table Of Contents
100T-CP Cathodic Protection Telemetry Module Overview
TDC
-1344-000 100T-CP Cathodic Protection Telemetry Module Installation Guide 3
Proprietary and Confidential
Installation Prerequisites
The following tools are required to install, program, and check the 100T-CP module. Specific tools may be
required for some installation locations.
• Medium flat-blade screwdriver
• Medium Phillips screwdriver
• Hand pliers
• Side-cutting pliers
• Nut driver with sockets
• Adjustable wrench
• 3M Scotchlock E-9Y crimping tool, 3M Scotchlock E-9C cartridge tool, or similar crimping tool
• All-weather electrical tape
• Voltmeter
• Itron programming device to program and check 100T-CP module installation and operation.
Note See the FDM programming guide or specification sheet for correct software version
Related
Documents on page 2.