User's Manual
Table Of Contents
Mounting the 100T-CP Module on the Test Station Post
TDC
-1344-000 100T-CP Cathodic Protection Telemetry Module Installation Guide 8
Proprietary and Confidential
12. Thread the 100T-CP cable through the hole previously drilled in the riser post and gently pull the cable
through the top of the riser post.
13. Slide the 100T-CP module mounting post slot onto the mounting post on the adapter plate. Align the
100T-CP mounting screw holes with those on the adapter plate. Verify the cable is on the left side of the
mounting post slot.
14. Insert the mounting screws and tighten in an alternating pattern.