User's Manual

Chapter 2 Installing the 100G Remote ERT Module
4. Pull the cable tie tight and cut off excess length. Dispose of the cut-off piece properly.
When finished, the tamper seals and cable should look like this.
Functional Specifications
Power source: Lithium battery
Radio programming parameters: LCD reading, number of digits, count rate, security
level
Mercury corrector programming parameters:
• Correctors must have Form A board. Form C is NOT supported.
• Item # 056: Pulse A Scaling. Set at 2.0000 for a form A switch.
• Item #057: Pulse A Scaling. Set at 2.0000 for a form A switch.
• Item #058: Pulse A Scaling. Set at 2.0000 for a form A switch.
30 Natural Gas Solutions 100G Installation Guide for Mercury Electronic Volume Correctors
DRAFT