User's Manual

Chapter 2 Installing the 100G Remote ERT Module
2. Read the ERT module assembly using the FC200SR. Consult the EndPoint-Link ERT
Programming Guide
(TDC-0411) or other applicable instructions for details on how to
read an ERT.
• If this reading is higher than the one you programmed in step 1 above, the ERT
module assembly is counting correctly.
• If the ERT module assembly reading is
not higher than what was programmed
in step 1, replace the ERT module with a new one.
To connect the ERT cable to the corrector
1. Insert the ERT cable into the compression connector.
2. Strip one inch from the outer insulation and about 1/4-inch from the red,white and
blue wires. Twist the blue and white wires together.
26 Natural Gas Solutions 100G Installation Guide for Mercury Electronic Volume Correctors
DRAFT