User's Manual

Chapter 2 Installing the 100G Remote ERT Module
6. Push any excess wire up between the back of the ERT module and the face of the
adapter plate.
Flat Surface Mounting
To mount the 100G Remote ERT Module on a flat surface
1. Drill three pilot holes in the mounting surface the proper size for the mounting screws,
as shown in the drilling template.
WARNING! Do not strike electrical wires or damage anything on the other side
of the surface you are going to mount the ERT module on when you drill the
holes and install the screws.
22 Natural Gas Solutions 100G Installation Guide for Mercury Electronic Volume Correctors
DRAFT