User's Manual

Installation Prerequisites
100G Datalogging
Installation Guide – Remote Disconnect
TDC-0884-000 9
Installation Prerequisites
Prior to installation, verify you have the following items:
• 100G Datalogging Gas Endpoints designed for your specific brand of residential or
commercial gas meters (endpoints include new tamper seals).
• A METRIS 250 meter (see the Meter Compatibility List on page 8).
• A compatible index. Itron 100G Datalogging Gas Endpoints are compatible with
standard dial and direct-read (odometer) indexes. Exceptions are noted on the Meter
Compatibility List on page 8.
• Installation tools (provided by installer or customer)
• Small and medium flat-blade or Phillips screwdrivers - to remove and tighten
index and index-cover screws.
• Side-cutting pliers/wire snips - to cut wire seals, if applicable.
• Small putty knife - residential meters.
• Meter seals, wire seal, and seal press - to protect the meter from tampering, if
applicable.
• 11/32-inch nut driver or other blunt tool - to securely seat new tamper plugs
over screw holes.
• FC200SR handheld computer with Endpoint-Link or Endpoint-Link Pro
software - to program and check 100G Datalogging Gas Endpoint installation
and operation.
Caution The 100G Datalogging Gas Endpoints can only be programmed using
FC200SR Handheld Computers loaded with Endpoint-Link or Endpoint-Link Pro
software version 5.3 or later.
• Replacement screws - to mount the 100G Datalogging Gas Endpoint assembly
to the meter and the index to the endpoint housing:
Replacement Screws
Residential Meter To mount the 100G
Datalogging Gas
Endpoint on the
meter:
Itron Part
Number
To mount the index on the 100G
Datalogging Gas Endpoint
housing:
Itron Part
Number
Itron METRIS 250
10 - 24 x 5/8" slotted
Fillister head
10 - 24 x 1/4" slotted, round
pan-head