User's Manual
Table Of Contents
- Document Conventions
- 100G Datalogging Remote Disconnect Gas Endpoint
- Itron METRIS 250 Meter Installation
- To remove the index from the meter
- To assemble the 100G Datalogging Remote Disconnect Gas endpoint and index
- To program the 100G Datalogging Remote Disconnect Gas endpoint
- To attach the 100G Datalogging Gas Endpoint to the meter
Chapter 2 Itron METRIS 250 Meter Installation
1. Place a new tamper seal over the two screws in the tamper seal cups. Press the new
tamper seals into place using an 11/32-inch nut driver or similar blunt tool.
2. Complete any necessary paperwork and properly dispose excess installation materials
and scrap from the customer premises.
100G Datalogging Gas Remote Disconnect endpoint installation on the Itron METRIS 250
Meter is complete.
18 100G Dataloggin
g
Installation Guide – Remote Disconnec
t
TDC-0884-00
0