User's Manual
Table Of Contents
- Document Conventions
- 100G Datalogging Remote Disconnect Gas Endpoint
- Itron METRIS 250 Meter Installation
- To remove the index from the meter
- To assemble the 100G Datalogging Remote Disconnect Gas endpoint and index
- To program the 100G Datalogging Remote Disconnect Gas endpoint
- To attach the 100G Datalogging Gas Endpoint to the meter
Chapter 2 Itron METRIS 250 Meter Installation
16 100G Dataloggin
g
Installation Guide – Remote Disconnec
t
TDC-0884-00
0
Attaching the 100G Datalogging Remote Disconnect Gas
Endpoint Assembly to the Meter
After programming the 100G Datalogging Remote Disconnect Gas endpoint, attach it to the
Itron METRIS meter.
To attach the 100G Datalogging Gas Endpoint to the meter
1. Align the endpoint communications plug with the meter receptacle. Insert the
endpoint communications plug into the meter receptacle and push gently until the plug
snaps into place.
Endpoint communications plug Meter receptacle
Warning The communications plug notch must align with the meter receptacle
notch. Verify the notches are properly aligned before pushing the
communications plug into place. Do not force the plug if the notches are not
aligned.