User's Manual

Electronic Instrument Installation
7. Insert the gel-connected wires into the threaded gray adapter plate hole.
8. Replace the strain relief and tighten until secure.
Honeywell Software Settings
The Honeywell MasterLink SQL software is used to configure Honeywell products.
Important This information is subject to change without notice. Refer to the
Honeywell MasterLink SQL product documentation to verify the most current
information about programming and configuring the corrector for use with the 100G
series remote ERT module.
To review instrument settings
1. Connect the interface cable from the Honeywell instrument to a PC loaded with the MasterLink SQL
software.
2. Open the MasterLink SQL software.
The software opens and reports a "Not Connected" status.
The Site List window automatically opens after the software detects an instrument.
3. Select the Honeywell instrument type from the Instrument List on the right of the screen.
Important You must select the correct instrument type. Selecting the incorrect type causes
communication errors.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 50
Proprietary and Confidential