User's Manual

This chapter provides the instructions to install 100G series remote gas modules (Itron part number ERG-

500X-501 with 2.5 foot cable and encoder) on diaphragm gas meters where a direct mount ERT module is not

possible. Reference the Itron 100G Series Remote ERT Module Meter Compatibility List on page 4 for

compatible diaphragm meters.

Tools and Materials Supplied By You

Note 100G series remote gas module installation to a diaphragm meter may

require additional tools and materials over those listed in Installation

Prerequisites.

The following user/installer-supplied tools and materials are required to install, program, and check the

• Medium flat-blade screwdriver

• Medium flat-blade, torque-measuring screwdriver

• Medium Phillips screwdriver

• Pliers

• Side-cutting pliers or similar tool

• 1/4-inch nut driver or other blunt tool

• Itron programming device:

FC200SR handheld computer with Field Deployment Manager (FDM) software

FC300 with SRead with Field Deployment Manager (FDM) software

900 MHz Belt Clip Radio with Field Deployment Manager (FDM) and a customer-supplied laptop

Note The FDM version required is dependent upon the model in use.

• 1-inch putty knife or similar tool

• Replacement temperature compensation (TEMP COMP) meter index stickers (if required)

C HAPTER 5

iaphragm Meter Installation

TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 77

Proprietary and Confidential