User's Manual

Electronic Instrument Installation
14. Select the following parameters:
• Connection Type: Direct
• Communications Port: Enter your computer's port number
• Baud Rate: Enter the baud rate for the XARTU-1 corrector.
15. Verify the time and station name are correct.
16. Click OK.
17. Click View/Config.
18. Click the Setup Parameters tab at the bottom of the parameters window.
The Meter Setup and Accumulation Multipliers window opens.
Set up the meter and accumulation multipliers as appropriate for your installation.
19. Enter the following parameters in the Uncorrected Pulse Output Setup section in the lower right of the
window.
• Select the channel to K2.
• Enter the number of Current/Test Pulses to Output desired to test the connection.
• Enter the same setting as the ERT module. For example, if the ERT module consumption is in MCU
(thousand cubic feet), set Out Cubic Unit/Pulse to 1000.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 68
Proprietary and Confidential