User's Manual

Electronic Instrument Installation
For uncorrected leads:
7. Insert the flying leads from the remote ERT module into the compression connector on the right of the
XARTU-1 corrector housing.
8. Pull the lead wires through the compression connector until there is adequate wire to reach the K2 the
terminal port.
9. Tighten the compression connector.
10. Connect the red remote ERT module wire to pin 4 of the K2 terminal port.
11. Twist the remote ERT module's blue and white wires together.
12. Connect the twisted blue and white wires to pin 5 of the K2 terminal port. The following illustration
shows the completed connections.
13. Plug the MTA battery connector from the battery pack into the VBAT1 connector to supply power to the
XARTU-1 corrector.
14. Close and latch the corrector door.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 62
Proprietary and Confidential