User's Manual

Electronic Instrument Installation
To connect the 100G ERT module to the MPplus corrector
For corrected reads (ERT module mounted to the left of the corrector):
1. With the XARTU-1 door open, insert the flying leads from the remote ERT module into the compression
connector on the left of the corrector's housing.
2. Pull the lead wires through the compression connector until there is adequate wire to reach the K1
terminal port.
3. Tighten the compression connector.
4. Connect the red remote ERT module wire to pin 1 on the K1 terminal port .
5. Twist the remote ERT module's blue and white wires together.
6. Connect the twisted blue and white wires to terminal 2 on the K1 terminal port. The following illustration
shows the completed connections.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 61
Proprietary and Confidential