User's Manual

Electronic Instrument Installation
1. Mount a remote ERT module on each end of the mounting rail using the mounting screws supplied with
the ERT modules.
Note The notch on the mounting rail is the front bottom of the rail. The ERT modules mount to the back
of the mounting rail as shown.
2. Insert tamper seals into the tamper seal mounting cups on the remote ERT modules.
3. With the corrector facing forward, align the corrector mounting holes with the index drive mounting holes.
4. Insert the corrector's mounting screws in the front corrector and index mounting holes. Loosely tighten the
front two mounting screws.
5. Align the inside mounting rail screw holes over the back index and corrector mounting screw holes.
6. Insert the two remaining mounting screws in the corrector bracket mounting holes.
7. Tighten all four mounting screws.
To connect the 100G ERT module to the MPplus corrector
For uncorrected reads:
1. With the MPplus door open, insert the flying leads from the remote ERT module into the compression
connector on the left of the MPplus housing.
2. Pull the lead wires through the compression connector until there is adequate wire to reach the terminal
blocks labeled 15, 16, 17, 18, 19, 20, 21, and 22.
3. Tighten the compression connector.
4. Twist the remote ERT module's blue and white wires together.
5. Connect the twisted blue and white wires to terminal 17 on the MPplus terminal block.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 59
Proprietary and Confidential