User's Manual

Rotary Meter Installation
3. Attach the mounting plate to the meter. Insert the mounting screw where the module screw was removed.
Torque the mounting screw to 5-7 ft.lbs. to secure the plate to the Romet meter.
4. Mount the 100G series remote gas module using the pre-drilled holes on the mounting plate and the
module mounting screws.
5. Place new tamper seals over the two screws. Press tamper seals into place using an 11/32-inch nut driver
or similar blunt tool.
6. Connect the module to the meter using the previously installed cable interface.
Installing the Remote ERT Module to the Elster American Meter
RPM Series Rotary Meter
Some meter manufacturers provide ERT mounting kits and installation procedures for their meters. If 100G
series remote gas module to Elster American RPM meter installation instructions are not available, follow the
installation procedure in this section.
Elster American Meter RPM Series Rotary Meter
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 34
Proprietary and Confidential