User's Manual

Rotary Meter Installation
4. Install the bottom two mounting screws and Kep nuts. Tighten the three mounting screws in an alternating
pattern.
5. Install the supplied red tamper seals over the bottom mounting screws on the ERT module.
Connecting and Installing the 100G Series Module to the GE
Dresser ES3 or ETC
Meter manufacturers may provide ERT mounting kits and installation procedures. If GE Dresser's 100G series
to GE Dresser ES3 or ETC device installation procedure is not available, follow this procedure.
Note You must purchase the ES3 or ETC device as AMR Ready from GE Dresser. A
successful installation requires an AMR Ready ES3 or ETC. Reference the GE Dresser
MeterWare software manual for configuration information.
To prepare the GE Dresser ES3 or ETC for the ERT module installation
1. Score (cut) the cable jacket surrounding the ES3 or ETC wires.
2. Carefully remove the cable jacket to expose the ES3 or ETC wires.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 26
Proprietary and Confidential