User's Manual

Rotary Meter Installation
5. Install the ERT module back plate using the T-15 Torx screws supplied with the ERT module.
To mount the ERT module on the D800 or D1000 meter
1. Route the cable through the channel in the backplate standoffs.
2. Insert the 8-32 x 1/2" screw into the top hole in the meter mounting bracket and thread one of the Kep
nuts loosely onto the end of the screw.
3. Tilt the bottom of the ERT module away from the mounting bracket and slide the notched mounting hub
onto the screw and Kep nut. Do not tighten the screw.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 25
Proprietary and Confidential