User's Manual

Mounting the 100G Series Gas ERT Module
4. Install the bottom two mounting screws. Fasten the screws in an alternating pattern until fully tightened to
secure the module firmly in position.
To install tamper seals and cable ties
1. Place a new tamper seal (from the Pipe Installation Kit) over each ERT module mounting screw.
2. Firmly push both tamper seals into place with a 1/4-inch nut driver or similar blunt tool.
Note A tamper seal is fully seated when the top of the tamper seal is approximately 1/16-inch below the
top of the screw recess.
3. To reduce the risk of cable damage, secure the excess module cable with the cable ties from the Pipe
Mount Installation Kit. Pull the cable tight. Remove and properly dispose the excess cable tie.
100G series remote gas module installation on a vertical flat surface or wall is complete.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 17
Proprietary and Confidential