User's Manual

Mounting the 100G Series Gas ERT Module
Mounting the Remote Gas Module on a Wall or Other Flat
Vertical Surface
Carefully select a mounting location free from electrical wires. The mounting location must have the proper
clearance to accommodate the 1-1/2-inch module mounting screws so nothing is damaged by the drill or
mounting screws.
Note For easier installation, drill three pilot holes in the mounting surface (use the correct size drill
bit to accommodate the module mounting screws [see the drilling template below]). The drilled pilot
holes for the two bottom screws must be on a horizontal line. To mount the module on a sheet metal
surface, use the mounting screws included with the Remote Mounting kit. Use a comparable wood
screw to mount the module on a vertical wood surface.
Remote module drilling template
A 3 inches
B 1-11/16 inches
C 3-3/8 inches
To mount the remote gas module on a wall or other flat vertical surface
1. Using one of the three 1-1/2-inch mounting screws from the Pipe Mount Kit, turn the mounting screw for
the mounting lug (top of module) part way into the mounting surface.
2. Place the 100G series remote gas module mounting lug recess (on the top of the module backplate) just
under the screw head.
3. Slide the module upward until the screw head fits completely inside the mounting lug recess. Several
adjustments may be necessary to properly position the screw for module mounting.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 16
Proprietary and Confidential