User's Manual

Mounting the 100G Series Gas ERT Module
1. Place the adapter plate on the pipe bracket with the mounting lug at the top or bottom. The adapter plate
screw bosses fit into the pipe bracket recess.
2. Ensure the adapter plate is positioned as shown below with the mounting lug (1) at the top or bottom. To
install the adapter plate on a vertical pipe, use the two shortest (1/2-inch) adapter plate mounting screws
from the installation kit. Place the mounting screws (2) in the holes shown below.
3. Tighten both screws securely in an alternating pattern. Tighten to 9 - 12 inch-pounds torque.
To mount the 100G series remote gas module on the adapter plate
1. Using the ERT module and the two one-inch mounting screws from the Pipe Installation kit, place the
back of the remote ERT module against the face of the adapter plate. The adapter plate mounting lug (1)
must be positioned just above the ERT module mounting lug recess (2).
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 13
Proprietary and Confidential