User's Manual

Mounting the 100G Series Gas ERT Module
To mount the pipe bracket on a vertical pipe
Caution A vertical mounting position is important to maximize RF performance. Mount the ERT module
with the module's label arrow pointing up. The module's arrow must never point to either side or upside
down. The module's tilt tamper functionality is designed to operate with the module installed vertically.
1. Remove the pipe bracket and band clamp from the Pipe Mount Installation Kit (Itron part number CFG-
0005-003).
2. Loosen the band clamp screw until the end of the band releases.
3. Push the end of the clamp's band through the holes in the pipe bracket. The pipe bracket must be oriented
as shown below.
4. Place the band clamp around the pipe. The band will loosely wrap around the pipe.
5. Push the end of the band through the band clamp screw assembly. Turn the band clamp's screw assembly
to fit into the pipe bracket opening. Tighten the clamp screw until the band clamp is secure on the pipe.
Caution The pipe bracket must fit firmly against the pipe to prevent slippage.
Adapter Plate Mounting Positions
The following pictures show adapter plates mounted on horizontal or 45-degree angle pipes.
Caution Regardless of the pipe's direction, the adapter plate mounting lug must always be at the top.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 11
Proprietary and Confidential